Seagate ST3400601U2

Seagate Barracuda Disks, and especially the Seagate 7200.7, Seagate 7200.8, Seagate 7200.9 and Seagate 7200.10 series have a very common problem with heads and firmware failure. Seagate introduced new technology to thisfamily of hard disks; they created a special coating for the platters that was supposed to protect magnetic layer.

Seagate Electronic Failure: A Seagate electronic fault will develop on the Seagate controller board. This failure will often involve multiple components on the electronic board. With Seagate PCB failures of this type the drive will appear dead and will not be recognised by the Computer BIOS when the computer boots up.

Factory Firmware: This is the software code that makes the drive function correctly. On Segate hard Disks the Firware is prone to corruption which makes the drive and all data inaccessible. Disks with firmware corruption have some of the following symptoms:

1. Be recognised incorrectly in the Computer BIOS.
2. Not be recognised at all in the Computer BIOS

The most common fault with a Seagate drive is when the Seagate hard disk will start and is recognised in the computer BIOS but the computer will then run slowly and will stall the computer. A 'ticking' sound will also be coming from the Seagate hard drive.

We can perform a full data recovery on all Segate Desktop and Notebook series Disks.

1. Clicking / Ticking / Scratching / Grinding Sounds
2. Not spinning, Not powering on at all
3. Drive not working after Power Surge
4. Freezing or locking up the computer
5. Not detected by computer's CMOS/BIOS
6. Corrupted partition
7. Accidental reformatting of partitions, Accidental Deletion of Data, Virus Problems
8. Hard disk is unable to be accessed ( Inaccessible drive or partition )
9. Unable to boot computer
10. The disk is seen in Operating System but asking to be formatted
11. Unable to access drive with an error message
12. Error reporting ' Primary Master disk failed, Press F1 to continue'
13. When the computer is powered on the BIOS will fail to identify the drive

Data recovery process often involves replacing failed or damaged hard drive's components in a clean environment. The failed components typically include the read/write heads and drive's motor. Firmware corruption: If you have seen these hard disk names on the BIOS screen - Maxtor N40P, Maxtor Athena, Maxtor Ares C64K, Maxtor Calipso, Maxtor Falcon, Maxtor Proxima, Maxtor Vulcan, Maxtor Romulus, Maxtor Rigel, WDC ROM MODEL-HAWK, WDC-ROM SN# 254, DeskStar Click of Death - instead of the real model name, it means that the BIOS does not identify the presence of the hard drive or identifies it incorrectly by its factory code, putting alias instead of the original hard disk ID. Mechanical: It is usually a result from a motor bearing failure or read write head failure. It occurs if the motor overheats and stops spinning or the read write head gets damaged.. The hard drive's heads and/or platters are most probably damaged, when you can hear a clicking, scraping or grinding noise. Electronic: The hard drive will appear dead, not spinning and not being recognised by the BIOS. All hard disks have a circuit board (PCB Board), and this board allows the drive to communicate with the computer. A burned chip on the PCB controller or damaged circuits are common reasons of electronic failure (PCB Failure). Heat can cause the electronics to fail. Power surges are also one of the most common problems. The smell of burnt circuits combined with the sight of smoke coming out of your computer is something indicating about the damage of the PCB board.

Most often requested Segate Desktop Disks for Data Recovery are below.

Click on your drive model from the table that is linked to the specific data recovery information

All Seagate Data Recovery is NOW £249.99

If you need more information on our Data Recovery Services or to confirm a Data Recovery Quote call us on 0800 075 0720, or email us on email address's below. We are open Monday - Friday 9am - 6pm GMT.

For more information and quotes: sales@choicedatarecovery.co.uk

For support updates:support@choicedatarecovery.co.uk